Table of Contents
Advertisement
SNMP Commands
snmp-server group
snmp-server group
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Default Configuration
N/A
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# snmp-server engineid remote 172.10.77.1 00036D0012
To define an SNMP group, use the snmp-server group Global Configuration mode
command. Groups are used to map SNMP users to SNMP views (using the snmp-
server user command).
To delete an SNMP group, use the no form of this command.
Syntax
groupname
snmp-server group
readview
write-view
no snmp-server group
Parameters
groupname
•
—The SNMP group name. (Length: 1 to 30 characters)
•
{v1 | v2c | v3}—Specifies the SNMP version.
•
noauth—Specifies that no packet authentication will be performed.
Applicable only to the SNMP version 3 security model.
•
auth—Specifies that packet authentication without encryption will be
performed. Applicable only to the SNMP version 3 security model.
•
priv—Specifies that packet authentication with encryption will be
performed. Applicable only to the SNMP version 3 security model. Note that
creation of SNMPv3 users with both authentication and privacy must be
done in the GUI. All other users may be created in the CLI.
{v1 | v2c | v3} {noauth | auth | priv} read-view
writeview
[notify-view
groupname
{v1 | v2c | v3} {noauth | auth | priv}
notifyview
]
32
442
Advertisement
Table of Contents
