Dot1X Reauthentication - Cisco 220 Series Smart Plus Reference Manual

802.1X Commands

dot1x reauthentication

dot1x reauthentication
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Example
The following example enables 802.1X authentication in auto mode on gi 1 5:
switchxxxxxx(config)# interface gi15
switchxxxxxx(config-if)# dot1x port-control auto
To enable periodic reauthentication of the client, use the dot1x reauthentication
Interface Configuration (Ethernet) mode command.
To disable periodic reauthentication of the client, use the no form of this command.
Syntax
dot1x reauthentication
no dot1x reauthentication
Parameters
N/A
Default Configuration
Periodic reauthentication is disabled.
Command Mode
Interface Configuration (Ethernet) mode
Example
switchxxxxxx(config)# interface gi15
switchxxxxxx(config-if)# dot1x reauthentication
2
40