RMON Commands
rmon history
rmon history
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Default Configuration
If the owner name is not specified, the default is an empty string.
Command Mode
Global Configuration mode
Example
The following example configures an event identified as index 10, for which the
switch generates a notification in the log table:
switchxxxxxx(config)# rmon event 10 log
To configure a RMON MIB history on an Ethernet interface, use the rmon history
Global Configuration command.
To remove a RMON history, use the no form of this command.
Syntax
index
rmon history
interface
seconds
NAME
| owner
no rmon history
index
Parameters
index
•
—The history index. (Range: 1 to 65535)
•
interface
interface-id
bucket-number
•
buckets
buckets desired for the RMON collection history. (Range: 1 to 50)
seconds
•
interval
the data is sampled and compared with the rising and falling thresholds.
(Range: 1 to 3600)
NAME
•
owner
—(Optional) Specifies the name of the person who configured
this history.
interface-id
[buckets
]
—Specifies the interface to be sampled.
—(Optional) Specifies the maximum number of
—(Optional) Specifies the interval in seconds during which
bucket-number
] [interval
30
379