Ethernet Configuration Commands
storm-control unknown-multicast level
storm-control unknown-multicast level
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To configure the maximum rate of unknown multicast traffic on an interface, use
the storm-control unknown-multicast level Interface Configuration mode
command.
To revert to its default setting, use the no form of this command.
Syntax
storm-control unknown-multicast level {
no storm-control unknown-multicast level
Parameters
pps
kbps
•
{
|
}—Specifies the maximum rate of unknown multicast traffic on an
interface. The unit of this rate depends on the settings in the storm-control
unit Global Configuration mode command. (Range: 1 to 262134 pps or 16 to
1000000 kbps)
Default Configuration
10000
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Use the storm-control unknown-multicast level Interface Configuration mode
command to enable storm control of unknown multicast traffic on an interface.
The calculated rate includes the 20 bytes of Ethernet framing overhead
(preamble+SFD+IPG).
Example
switchxxxxxx(config)# interface gi1
switchxxxxxx(config-if)# storm-control unknown-multicast level 12345
pps
kbps
|
}
11
175