Table of Contents
Advertisement
IPv6 MLD Snooping Commands
ipv6 mld snooping vlan query-interval
ipv6 mld snooping vlan query-interval
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
•
Queries received on the port
•
PIM/PIMv2 received on the port
•
DVMRP received on the port
•
MOSPF received on the port
You can execute the command before the VLAN is created.
Example
switchxxxxxx(config)# ipv6 mld snooping vlan 1 mrouter learn pim-dvmrp
To configure IPv6 MLD snooping query interval on the switch or on a VLAN, use the
ipv6 mld snooping vlan query-interval Global Configuration mode command. This
time interval is the maximum time that a multicast router waits after issuing an
MASQ before deleting a port from the multicast group.
To revert to the default settings, use the no form of this command.
Syntax
ipv6 mld snooping vlan
no ipv6 mld snooping vlan
Parameters
VLAN-LIST
•
—A VLAN ID or a list of VLAN IDs.
•
VALUE
—The IPv6 MLD snooping query interval. (Range: 30 to 18000)
Default Configuration
The default VLAN query interval is 125 seconds.
Command Mode
Global Configuration mode
VLAN-LIST
query-interval
VLAN-LIST
query-interval
VALUE
19
288
Advertisement
Table of Contents
