Table of Contents
Advertisement
ACL Commands
permit (IP)
permit (IP)
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Parameters
value
•
—Sequence name of the ACL. The acceptable range is from 1 to
2147483547.
Command Mode
IP Access-List Configuration mode, IPv6 Access-List Configuration mode, and
MAC Access-List Configuration mode
Example
switchxxxxxx(config)# mac access-list extended macac11
switchxxxxxx(config-mac-acl)# show access-list
MAC access list macac11
....sequence 1 permit any any
switchxxxxxx(config-mac-acl)# no sequence 1
To set permit conditions for an IPv4-based ACL, use the permit IP Access-List
Configuration mode command.
To remove an IPv4-based ACE, use the no sequence command.
Syntax
value
[sequence
] permit
destination-wildcard
value
[sequence
] permit
destination-wildcard
number
precedence
]
value
[sequence
] permit
port-range
destination destination-wildcard
} {any |
range
number
} [dscp
value
[sequence
] permit
port-range
destination destination-wildcard
} {any |
range
number
} [dscp
value
no sequence
protocol
source source-wildcard
{any |
number
} [dscp
| precedence
icmp
source source-wildcard
{any |
icmp-type
} [any |
] [any |
tcp
source source-wildcard
{any |
number
| precedence
udp
source source-wildcard
{any |
number
| precedence
} {any |
number
]
} {any |
icmp-code
number
] [dscp
} {any |
destination-port
} {any |
list-of-flags
] [match-all
} {any |
destination-port
} {any |
]
4
destination
destination
|
source-port/
port-
/
]
source-port/
port-
/
79
Advertisement
Table of Contents
