Lldp Tx-Delay - Cisco 220 Series Smart Plus Reference Manual

LLDP Commands

lldp tx-delay

lldp tx-delay
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Parameters
N/A
Default Configuration
Transmitting LLDP is enabled on each interface.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
LLDP manages LAG ports individually. LLDP sends separate advertisements on
each port in a LAG.
LLDP operation on a port is not dependent on the STP state of a port. For example,
LLDP frames are sent on the blocked ports.
If a port is controlled by 802.1x, LLDP operates only if the port is authorized.
Example
switchxxxxxx(config)# interface gi5
switchxxxxxx(config-if)# lldp transmit
To set the delay time between two successive LLDP frame transmissions initiated
by value or status changes in the LLDP local system MIB, use the lldp tx-delay
Global Configuration mode command.
To revert to its default setting, use the no form of this command.
Syntax
seconds
lldp tx-delay
no lldp tx-delay
Parameters
seconds
• —The delay time in seconds. (Range: 1 to 8191 seconds)
22
331