Table of Contents
Advertisement
QoS Commands
qos aggregate-policer
qos aggregate-policer
NOTE
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
•
ports-not-trusted mode—For packets that are classified to the QoS action
trust.
•
ports-trusted mode—For packets that are not classified to any QoS action
or classified to the QoS action trust.
Example
The following example sets CoS as the trust mode in QoS advanced mode:
switchxxxxxx(config)# qos advanced-mode trust cos
To define the policer parameters that can be applied to multiple traffic classes
within the same policy map, use the qos aggregate-policer Global Configuration
mode command.
To remove an existing aggregate policer, use the no form of this command.
This command is only available when the switch is in QoS advanced mode.
Syntax
qos aggregate-policer
forward}]
no qos aggregate-policer
Parameters
name
•
—The aggregate policer name.
committed-rate-kbps
•
(kbps). (Range: 16 to 1000000)
•
exceed-action {drop | forward}—(Optional) Specifies the action to be taken
when the rate is exceeded. The possible values are:
-
drop—Drops the packet.
-
forward—Forwards the packet.
name committed-rate-kbps
name
—The average traffic rate (CIR) in kbits per second
[exceed-action {drop |
28
390
Advertisement
Table of Contents
