Ipv6 Mld Snooping Vlan Last-Member-Query-Count - Cisco 220 Series Smart Plus Reference Manual

IPv6 MLD Snooping Commands

ipv6 mld snooping vlan last-member-query-count

ipv6 mld snooping vlan last-member-query-count
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Example
switchxxxxxx(config)# ipv6 mld snooping vlan 1 forbidden forward-all
interfaces fa1
switchxxxxxx(config)# ipv6 mld snooping vlan 1 forbidden forward-all
interfaces gi1
switchxxxxxx(config)# ipv6 mld snooping vlan 1 forbidden forward-all
interfaces po5
To configure IPv6 MLD multicast Address Specific Queries (MASQs) that will be
sent before aging out a client, use the ipv6 mld vlan snooping last-member-query-
count Global Configuration mode command.
To revert to the default settings, use the no form of this command.
Syntax
ipv6 mld snooping vlan
no ipv6 mld snooping vlan
Parameters
VLAN-LIST
• —A VLAN ID or a range of VLAN IDs.
VALUE
• —The number of last member queries. (Range: 1 to 7)
Default Configuration
The default last member query count is 2.
Command Mode
Global Configuration mode
VLAN-LIST
last-member-query-count
VLAN-LIST
last-member-query-count
19
VALUE
285