Show Arp; Show Hosts - Cisco 220 Series Smart Plus Reference Manual

IP Addressing Commands

show arp

show arp

show hosts

Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To display all entries in the ARP table, use the show arp Privileged EXEC mode
command.
Syntax
show arp
Parameters
N/A
Command Mode
Privileged EXEC mode
Example
switchxxxxxx# show arp
Address
192.168.1.22
To display the DNS servers defined on the switch, use the show hosts Privileged
EXEC mode command.
Syntax
show hosts
Parameters
N/A
Command Mode
Privileged EXEC mode
Example
switchxxxxxx# show hosts
HWtype HWaddress
ether 00:10:60:DB:6E:FE
14
Flags Mask
C
Iface
eth0
233