Table of Contents
Advertisement
Power over Ethernet (PoE) Commands
power inline traps enable
power inline traps enable
power inline usage-threshold
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To enable inline power traps, use the power inline traps enable Global
Configuration mode command.
To disable inline power traps, use the no form of this command.
Syntax
power inline traps enable
no power inline traps enable
Default Configuration
Inline power traps are disabled by default.
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# power inline traps enable
To configure the threshold for initiating inline power usage alarms, use the power
inline usage-threshold Global Configuration mode command.
To revert to its default setting, use the no form of this command.
Syntax
power inline usage-threshold
no power inline usage-threshold
Parameters
percent
•
—The usage threshold in percentage of the power limit. An alarm is
initiated if the power exceeds this value. (Range: 1 to 99)
percent
25
362
Advertisement
Table of Contents
