Table of Contents
Advertisement
LACP Commands
lacp port-priority
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To set the Link Aggregation Control Protocol (LACP) priority for an interface, use
the lacp port-priority Interface Configuration mode command.
To revert to its default setting, use the no form of this command.
Syntax
VALUE
lacp port-priority
no lacp port-priority
Parameters
VALUE—
•
The LACP priority value for an interface. (Range: 1 to 65535)
Default Configuration
The default LACP port priority is 1.
Command Mode
Interface Configuration (Ethernet) mode
Example
switchxxxxxx(config)# interface gi6
switchxxxxxx(config-if)# lacp port-priority 247
20
303
Advertisement
Table of Contents
