Chapter 9: Configuration And Image File Commands; Boot Host Auto-Config - Cisco 220 Series Smart Plus Reference Manual

Configuration and Image File Commands

boot host auto-config

Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To enable the DHCP Auto Configuration feature on the switch, use the boot host
auto-config Global Configuration mode command.
To disable this feature on the switch, use the no form of this command.
Syntax
boot host auto-config
no boot host auto-config
Parameters
N/A
Default Configuration
DHCP Auto Configuration is enabled.
Command Mode
Global Configuration mode
User Guidelines
Auto Configuration enables passing configuration information to hosts on a TCP/IP
network. Based on this protocol, the Auto Configuration feature enables a switch
to download configuration files from a TFTP server. The switch can be configured
as a DHCPv4 client in which auto configuration from a DHCPv4 server is
supported or a DHCPv6 client in which auto configuration from a DHCPv6 server is
supported.
After the switch obtains information such as configuration file name and TFTP
server IP address from the DHCP server, it will first automatically download the
specific configuration file from the remote TFTP server, copy the downloaded
configuration to the startup configuration, and then reboot.
9
131