LLDP Commands
lldp med location
lldp med location
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
no lldp med fast-start-repeat-count
Parameters
number
•
—The number of times that the fast start LLDPDU is being sent
during the activation of the fast start mechanism. (Range: 1 to 10)
Default Configuration
The default value is 3.
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# lldp med fast-start-repeat-count 4
To configure the LLDP MED location for an interface, use the lldp med location
Interface Configuration mode command.
To remove the LLDP MED location for an interface, use the no form of this
command.
Syntax
lldp med location {civic-address
no lldp med location {civic-address | coordinate | ecs-elin}
Parameters
•
civic-address
hexadecimal format.
data
•
coordinate
hexadecimal format.
data
•
ecs-elin
—Specifies the location data as an Emergency Call Service
Emergency Location Identification Number (ECS ELIN) in hexadecimal
format.
data
| coordinate
data
—Specifies the location data as a civic address in
—Specifies the location data as coordinates in
data
data
| ecs-elin
}
22
321