Table of Contents
Advertisement
IP ARP Inspection Commands
show ip arp inspection
show ip arp inspection
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
User Guidelines
You must specify the VLANs on which to enable dynamic ARP inspection.
Dynamic ARP inspection is supported on access ports, trunk ports, EtherChannel
ports, and private VLAN ports.
Example
switchxxxxxx(config)# ip arp inspection vlan 5
To show the ARP Inspection status, use the show ip arp inspection Privileged
EXEC mode command.
Syntax
show ip arp inspection
Parameters
N/A
Command Mode
Privileged EXEC mode
Example
switchxxxxxx# show ip arp inspection
Dynamic ARP Inspection
Source Mac Validation
Destination Mac Validation : disabled
IP Address Validation
Enable on Vlans
The following table describes the significant fields shown in the example:
Field
Dynamic ARP
Inspection
: disabled
: disabled
: disabled
: None
Description
Shows whether dynamic ARP Inspection is enabled or
disabled on the switch.
15
242
Advertisement
Table of Contents
