Cisco 220 Series Smart Plus Reference Manual page 564

VLAN Commands
switchport general allowed vlan
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Parameters
vlan-list
• add —Adds a list of VLANs. Separate nonconsecutive VLAN IDs
with a comma and no spaces. Use a hyphen to designate a range of VLAN
IDs.
• tagged—(Optional) The port transmits tagged packets for the VLANs. This
is the default value.
• untagged—(Optional) The port transmits untagged packets for the VLANs.
vlan-list
• remove
IDs with a comma and no space. Use a hyphen to designate a range of
VLAN IDs.
Default Configuration
The port is an untagged member in the default VLAN. Packets are transmitted as
untagged.
Command Mode
Interface Configuration (Ethernet, port channel) mode
User Guidelines
You can change the egress rule (for example, from tagged to untagged) without
first removing the VLAN from the list.
Example
The following example sets gi 1 1 to the general mode and adds VLAN 2 to it.
Packets are tagged on the egress.
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# switchport mode general
switchxxxxxx(config-if)# switchport general allowed vlan add 2 tagged
—Removes a list of VLANs. Separate nonconsecutive VLAN
41
514