Table of Contents
Advertisement
IGMP Snooping Commands
ip igmp snooping vlan query-interval
ip igmp snooping vlan query-interval
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
switchxxxxxx(config)# ip igmp snooping vlan 1 querier version 3
To set the query interval on a VLAN, use the ip igmp snooping vlan query-interval
Global Configuration mode command.
To revert to its default setting, use the no form of this command.
Syntax
ip igmp snooping vlan
no ip igmp snooping vlan
Parameters
VLAN-LIST
•
—A VLAN ID or a list of VLAN IDs. (Range: 1 to 4094)
seconds
•
—The frequency in seconds at which IGMP query messages are
sent on the interface. (Range: 30 to 18000)
Default Configuration
The default IGMP query interval is 125 seconds.
Command Mode
Global Configuration mode
User Guidelines
You can execute the command before the VLAN is created.
Example
switchxxxxxx(config)# ip igmp snooping vlan 3 query-interval 50
VLAN-LIST
query-interval
VLAN-LIST
query-interval
seconds
13
211
Advertisement
Table of Contents
