Switchport General Allowed Vlan - Cisco 220 Series Smart Plus Reference Manual

VLAN Commands

switchport general allowed vlan

switchport general allowed vlan
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Syntax
switchport general acceptable-frame-type {tagged-only | untagged-only | all}
no switchport general acceptable-frame-type
Parameters
• tagged-only—Ignores (discards) untagged packets and priority-tagged
packets.
• untagged-only—Ignores (discards) VLAN-tagged packets (not including
priority-tagged packets)
• all—Does not discard packets untagged or priority-tagged packets.
Default Configuration
All frame types are accepted at ingress (all).
Command Mode
Interface Configuration (Ethernet, port channel) mode
Example
The following example configures gi3 as a general port and discards the untagged
frames at ingress:
switchxxxxxx(config)# interface gi3
switchxxxxxx(config-if)# switchport mode general
switchxxxxxx(config-if)# switchport general acceptable-frame-type tagged-only
General ports can receive tagged or untagged packets. To add or remove the
VLANs to or from a general port and configure whether packets on the egress are
tagged or untagged, use the switchport general allowed vlan Interface
Configuration mode command.
Syntax
switchport general allowed vlan {add
list
}
vlan-list
[tagged | untagged] | remove
41
vlan-
513