Table of Contents
Advertisement
RADIUS Commands
show radius-server
show radius-server
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
switchxxxxxx(config)# radius-server host radiusserver1 auth-port 20 timeout
20
To show information of the RADIUS servers defined on the switch, use the show
radius-server Privileged EXEC mode command.
Syntax
show radius-server
Command Mode
Privileged EXEC mode
Example
switchxxxxxx# show radius-server
Prio |
IP Address
------+---------------+----------+--------+--------+-----------+---------
1 |
10.193.22.1 |
The following table describes the significant fields shown in the example:
Field
Prio
IP Address
Auth-Port
Retries
Timeout
| Auth-Port| Retries| Timeout| Usage-Type|
1812
|
3
Description
Priority of the RADIUS server, where 0 has the highest
priority.
IP address or hostname of the RADIUS server.
UDP port number of the RADIUS server for
authentication requests. The value of zero indicates
that the host is not used for authentication.
Number of requests that are sent to the RADIUS server
before a failure is considered to have occurred.
Number of seconds that the switch waits for an answer
from the RADIUS server before retrying the query, or
switching to the next server.
|
3
|
All
29
Key
|
420
Advertisement
Table of Contents
