Storm-Control Enable - Cisco 220 Series Smart Plus Reference Manual

Ethernet Configuration Commands

storm-control enable

storm-control enable
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Example
switchxxxxxx(config)# interface gi1
switchxxxxxx(config-if)# storm-control broadcast level 12345
To enable storm control on an interface, use the storm-control enable Interface
Configuration mode command.
To disable storm control, use the no form of this command.
Syntax
storm-control enable
no storm-control enable
Parameters
N/A
Default Configuration
Disabled
Command Mode
Interface Configuration mode
Example
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# storm-control enable
11
172