Table of Contents
Advertisement
IPv6 Addressing Commands
management vlan ipv6-address-autoconfig
management vlan ipv6-address-autoconfig
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
switchxxxxxx(config)# management vlan ipv6-address 3000::123 prefix-length
64
To enable IPv6 address autoconfiguration on the switch, use the management vlan
ipv6-address-autoconfig Global Configuration mode command. Addresses are
configured depending on the prefixes received in the Router Advertisement
messages.
To disable IPv6 address autoconfiguration on the switch, use the no form of this
command.
Syntax
management vlan ipv6-address-autoconfig
no management vlan ipv6-address-autoconfig
Parameters
N/A
Default Configuration
IPv6 address autoconfiguration is enabled on the switch. No IPv6 address is
assigned by default.
Command Mode
Global Configuration mode
User Guidelines
When IPv6 address autoconfiguration is enabled, the router solicitation ND
procedure is initiated to discover a router and assign IP addresses to the switch,
based on the advertised on-link prefixes.
When disabling IPv6 address autoconfiguration, automatically generated
addresses that were assigned to the switch are removed.
The default state of IPv6 address autoconfiguration is enabled.
Example
18
272
Advertisement
Table of Contents
