Renew Dhcp Force-Autoconfig - Cisco 220 Series Smart Plus Reference Manual

Configuration and Image File Commands

renew dhcp force-autoconfig

renew dhcp force-autoconfig
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Parameters
N/A
Default Configuration
The DHCPv6 stateless client is disabled by default.
Command Mode
Global Configuration mode
Example
The following example enables the DHCPv6 stateless client on the switch:
switchxxxxxx(config)# management vlan ipv6 dhcp client stateless
To force the DHCP Auto Configuration procedure to be initated, use the renew
dhcp force-autoconfig Privileged EXEC mode command.
Syntax
renew dhcp force-autoconfig
Parameters
N/A
Default Configuration
N/A
Command Mode
Privileged EXEC mode
User Guidelines
After executing this command, the DHCP Auto Configuration procedure will start
on the next DHCP renew for DHCPv4 and on the next information-request refresh
for DHCPv6.
9
141