Table of Contents
Advertisement
Ethernet Configuration Commands
flowcontrol
flowcontrol
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# errdisable recovery cause all
switchxxxxxx(config)# errdisable recovery interval 64
To configure flow control on a given interface, use the flowcontrol Interface
Configuration mode command.
To disable flow control on an interface, use the no form of this command.
Syntax
flowcontrol {auto | on | off}
no flowcontrol
Parameters
•
auto—Automatically enables or disables flow control on the interface.
•
on—Enables flow control on the interface.
•
off—Disables flow control on the interface.
Default Configuration
Flow control is disabled.
Command Mode
Interface Configuration (Ethernet, port channel) mode
Example
switchxxxxxx(config)# interface gi1
switchxxxxxx(config-if)# flowcontrol on
11
160
Advertisement
Table of Contents
