Table of Contents
Advertisement
QoS Commands
qos advanced-mode trust
qos advanced-mode trust
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Example 2—The following example enables QoS advanced mode on the switch
with the ports-not-trusted option:
switchxxxxxx(config)# qos advanced
This action will cause loss of configuration.Proceed?(y)
To configure the trust mode in QoS advanced mode, use the qos advanced-mode
trust Global Configuration mode command.
To revert to its default setting, use the no form of this command.
Syntax
qos advanced-mode trust {cos | cos-dscp | dscp | ip-precedence}
no qos advanced-mode trust
Parameters
•
cos—Classifies ingress packets with the packet CoS values. For untagged
packets, the port default CoS is used.
•
cos-dscp—Classifies ingress packets with the packet DSCP values for IP
packets. For other packet types, use the packet CoS values.
•
dscp—Classifies ingress packets with the packet DSCP values.
•
ip-precedence—Classifies ingress packets with the packet precedence
values.
Default Configuration
The default trust mode is cos.
Command Mode
Global Configuration mode
User Guidelines
The configuration is relevant for QoS advanced mode in the following cases:
28
(Y/N)[Y]
389
Advertisement
Table of Contents
