Show Lacp - Cisco 220 Series Smart Plus Reference Manual

LACP Commands

show lacp

show lacp
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
—
• short Specifies that the periodic transmissions of LACP PDUs occur at a
fast transmission rate.
Default Configuration
The default timeout is long.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example assigns a long administrative LACP timeout to fa6:
switchxxxxxx(config)# interface gi6
switchxxxxxx(config-if)# lacp timeout long
To show LACP channel-group information, use the show lacp Privileged EXEC
mode command.
Syntax
show lacp sys-id
channel-group-number
show lacp [
channel-group-number
show lacp [
Parameters
• —
sys-id Displays the system identifier that is being used by LACP. The
system identifier is made up of the LAPC system priority and the switch
MAC address.
channel-group-number
•
range is 1 to 8.
—
• counters Displays traffic information.
—
• internal Displays internal information.
• neighbor — Displays neighbor information.
] counters
] {internal | neighbor} [detail]
—(Optional) Number of the channel group. The
20
305