Lldp Tlv-Select 802.1 - Cisco 220 Series Smart Plus Reference Manual

LLDP Commands
lldp tlv-select 802. 1

lldp tlv-select 802.1

Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To specify which 802.1x parameters will be advertised, use the lldp tlv-select
802.1 Interface Configuration mode command.
Syntax
lldp tlv-select 802.1 pvid enable
lldp tlv-select 802.1 pvid disable
lldp tlv-select 802.1 vlan-name add
lldp tlv-select 802.1 vlan-name remove
Parameters
• pvid enable—Specifies that the PVID is advertised.
• pvid disable—Specifies that the PVID is not advertised.
• vlan-name add
to 4094)
• vlan-name remove
(Range: 1 to 4094)
Default Configuration
802.1 pvid TLV is transmitted.
Command Mode
Interface Configuration (Ethernet) mode
Example
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# lldp tlv-select 802.1 pvid enable
vlan-id
vlan-id
vlan-id
—Specifies that the VLAN ID is advertised. (Range: 1
vlan-id
—Specifies that the VLAN ID is not advertised.
22
329