Table of Contents
Advertisement
802.1X Commands
dot1x timeout reauth-period
dot1x timeout reauth-period
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Parameters
seconds
•
—The time interval in seconds that the switch remains in a quiet
state following a failed authentication exchange with the client. (Range: 0 to
65535 seconds)
Default Configuration
The default quiet period is 60 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
During the quiet period, the switch does not accept or initiate the authentication
requests.
The default value of this command should only be changed to adjust to unusual
circumstances, such as unreliable links or specific behavioral problems with
certain clients and authentication servers.
To provide faster response time to the user, a smaller number than the default
value should be entered.
Example
The following example sets the time interval to 10 seconds:
switchxxxxxx(config)# interface gi15
switchxxxxxx(config-if)# dot1x timeout quiet-period 10
To set the number of seconds between reauthentication attempts, use the dot1x
timeout reauth-period Interface Configuration (Ethernet) mode command.
To revert to its default setting, use the no form of this command.
Syntax
dot1x timeout reauth-period
no dot1x timeout reauth-period
seconds
2
42
Advertisement
Table of Contents
