Cdp Log Mismatch Voip - Cisco 220 Series Smart Plus Reference Manual

CDP Commands

cdp log mismatch voip

cdp log mismatch voip
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Example
switchxxxxxx(config)# interface fa11
switchxxxxxx(config-if)# cdp log mismatch native
To enable validating that the VoIP status of the interface received in a CDP packet
matches its actual configuration, use the cdp log mismatch voip Interface
Configuration mode command.
To disable generating the SYSLOG messages for VoIP mismatches, use the no
form of this command.
Syntax
cdp log mismatch voip
no cdp log mismatch voip
Parameters
N/A
Default Configuration
The switch reports the VoIP mismatches from all interfaces.
Command Mode
Interface Configuration mode
User Guidelines
When a voice VLAN mismatch is detected, which means that the voice VLAN
information in the incoming frame does not match what the local device is
advertising, a SYSLOG message is generated by CDP.
Example
switchxxxxxx(config)# interface fa11
switchxxxxxx(config-if)# cdp log mismatch voip
7
109