Spanning-Tree Mode; Spanning-Tree Mst Configuration - Cisco 220 Series Smart Plus Reference Manual

STP Commands

spanning-tree mode

spanning-tree mode

spanning-tree mst configuration

Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To set the STP mode, use the spanning-tree mode Global Configuration mode
command.
Syntax
spanning-tree mode {mstp | rstp | stp}
Parameters
• mstp—Enables the Multiple STP (MSTP) mode.
• rstp—Enables the Rapid STP (RSTP) mode.
• stp—Enables the classic STP mode.
Default Configuration
The default mode is classic STP.
Command Mode
Global Configuration mode
User Guidelines
In the RSTP mode, the switch uses STP when the neighbor device uses STP.
In the MSTP mode, the switch uses RSTP when the neighbor device uses RSTP,
and uses STP when the neighbor device uses STP.
Example
switchxxxxxx(config)# spanning-tree mode mstp
To enter the MST Configuration mode and enable configuring an MSTP region, use
the spanning-tree mst configuration Global Configuration mode command.
Syntax
spanning-tree mst configuration
33
433