Table of Contents
Advertisement
802.1X Commands
show dot1x
show dot1x
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The default value of this command should be changed only to adjust to unusual
circumstances, such as unreliable links or specific behavioral problems with
certain clients and authentication servers.
Example
The following example sets the time interval to 3600 seconds:
switchxxxxxx(config)# interface gi15
switchxxxxxx(config-if)# dot1x timeout supp-timeout 3600
To show the 802.1X status, use the show dot1x Privileged EXEC mode command.
Syntax
show dot1x
Parameters
N/A
Default Configuration
N/A
Command Mode
Privileged EXEC mode
Example
switchxxxxxx# show dot1x
802.1x protocol is:
802.1x protocol version: 2
Enabled
2
44
Advertisement
Table of Contents
