Storm-Control Broadcast Level - Cisco 220 Series Smart Plus Reference Manual

Ethernet Configuration Commands

storm-control broadcast level

storm-control broadcast level
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Command Mode
Interface Configuration (Ethernet) mode
Example
switchxxxxxx(config)# interface fa5
switchxxxxxx(config-if)# storm-control broadcast
To configure the maximum rate of broadcast traffic on an interface, use the storm-
control broadcast level Interface Configuration mode command.
To revert to its default setting, use the no form of this command.
Syntax
storm-control broadcast level {
no storm-control broadcast level
Parameters
• { pps | kbps }—Specifies the maximum rate of broadcast traffic on a port. The
unit of this rate depends on the settings in the storm-control unit command.
(Range: 1 to 262134 pps or 16 to 1000000 kbps)
Default Configuration
10000
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Use the storm-control broadcast level command to enable storm control of
broadcast traffic on an interface.
The calculated rate includes the 20 bytes of Ethernet framing overhead
(preamble+SFD+IPG).
pps | kbps }
11
171