Table of Contents
Advertisement
LACP Commands
lacp system-priority
lacp system-priority
lacp timeout
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To set the global LACP priority for all interfaces, use the lacp system-priority
Global Configuration mode command.
To revert to its default setting, use the no form of this command.
Syntax
lacp system-priority
no lacp system-priority
Parameters
VALUE
•
—The LACP priority value for all interfaces. (Range: 1 to 65535)
Default Configuration
The default LACP system priority is 32768.
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# lacp system-priority 120
To assign an administrative LACP timeout to an interface, use the lacp timeout
Interface Configuration mode command.
Syntax
lacp timeout {long | short}
Parameters
—
•
long
Specifies that the periodic transmissions of LACP PDUs occur at a
slow transmission rate.
VALUE
20
304
Advertisement
Table of Contents
