Cdp Log Mismatch Duplex - Cisco 220 Series Smart Plus Reference Manual

CDP Commands

cdp log mismatch duplex

cdp log mismatch duplex
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
For example, if the TLV Advertise Interval is 30 seconds, and the Hold
Multiplier is 4, then the CDP packets are discarded after 120 seconds.
Default Configuration
The default CDP holdtime is 180 seconds.
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# cdp holdtime 120
To enable validating that the duplex status of an interface received in a CDP
packet matches its actual configuration, use the cdp log mismatch duplex
Interface Configuration mode command.
To disable generating the SYSLOG messages for duplex mismatches, use the no
form of this command.
Syntax
cdp log mismatch duplex
no cdp log mismatch duplex
Parameters
N/A
Default Configuration
The switch reports the duplex mismatches from all interfaces.
Command Mode
Interface Configuration mode
7
107