Cdp Device-Id Format; Cdp Enable - Cisco 220 Series Smart Plus Reference Manual

CDP Commands

cdp device-id format

cdp device-id format

cdp enable

Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
switchxxxxxx(config)# cdp appliance-vlan enable
To specify the format of Device-ID TLV, use the cdp device-id format Global
Configuration mode command.
Syntax
cdp device-id format {mac | serial-number | hostname}
Parameters
• mac—The Device-ID TLV contains the MAC address of the switch.
• serial-number—The Device-ID TLV contains the hardware serial number of
the switch.
• hostname—The Device-ID TLV contains the hostname of the switch.
Default Configuration
The MAC address of the switch is contained by default.
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# cdp device-id format serial-number
To enable CDP on an interface, use the cdp enable Interface Configuration mode
command.
To disable CDP on an interface, use the no form of this command.
7
105