Storm-Control Unknown-Unicast; Storm-Control Unknown-Unicast Level - Cisco 220 Series Smart Plus Reference Manual

Ethernet Configuration Commands

storm-control unknown-unicast

storm-control unknown-unicast

storm-control unknown-unicast level

Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To enable storm control for unknown unicast traffic on an interface, use the storm-
control unknown-unicast Interface Configuration mode command.
To disable storm control for unknown unicast traffic, use the no form of this
command.
Syntax
storm-control unknown-unicast
no storm-control unknown-unicast
Parameters
N/A
Default Configuration
Disabled
Command Mode
Interface Configuration (Ethernet) mode
Example
switchxxxxxx(config)# interface gi5
switchxxxxxx(config-if)# storm-control unknown-unicast
To configure the maximum rate of unknown unicast traffic on an interface, use the
storm-control unknown-unicast level Interface Configuration mode command.
To revert to its default setting, use the no form of this command.
Syntax
storm-control unknown-unicast level {
no storm-control unknown-unicast level
pps kbps
| }
11
176