Configuring The H.248-Based Voice Service (On A Web Page) - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide

12.4.2.5 Configuring the H.248-based Voice Service (on a Web Page)

The OLT is connected to the remote ONU through a GPON port to provide users with the IP-
based high-quality and low-cost VoIP service.
Prerequisite
l
l
l
l
Context
Table 12-37 Data plan
Item
ONU line profile
ONU service profile
Networking data
Procedure
l
Issue 01 (2014-04-30)
The interface data and POTS port data corresponding to the MG interface have been
configured on the MGC.
The OLT has been connected to the MGC. The OLT can ping the IP address of the MGC
server successfully.
The ONU has been added to the OLT. For details, see
OLT.
Different voice services require different ONU software versions. Before the configuration,
ensure that the ONU software version supports H.248. For details, see relevant ONU
manuals.
Configure the OLT.
1. Configure a traffic profile.
Set the profile name to ftto_voip and do not limit the upstream and downstream rates.
Set the priority to 5 and packets are scheduled according to the priority carried.
Run the display traffic table ip command to query existing traffic profiles in the
system. If the existing traffic profiles in the system do not meet the requirements, run
the traffic table ip command to add a traffic profile.
huawei(config)#traffic table ip name ftto_voip cir off priority 5 priority-
policy
local-setting
2. Configure the mapping between a GEM port and a VLAN. Create a service VLAN
and a service flow.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
12 FTTO Configuration(SOHO and SME)
Data
Profile name: ftto_line
T-CONT ID: 4
GEM port ID: 12
Profile name: ftto_ser
ONU port capability set: adaptive
IP address of the MGC server: 200.200.200.200/24
Port ID of the MGC server: 2944
12.3.3 Adding an ONU to an
1198