General Safety Guidelines For Electrical Equipment - Cisco Catalyst 8300 Series Hardware Installation Manual

Prepare for Installation
Warning
Note
Note
Note
Note

General Safety Guidelines For Electrical Equipment

Follow these general guidelines when working on equipment that is powered by electricity:
• Locate the emergency power-off switch in the room in which you are working. If an electrical accident
• Disconnect all power before doing the following:
• Look carefully for possible hazards in your work area, such as moist floors, ungrounded power extension
• Do not work alone if hazardous conditions exist.
• Never assume that power is disconnected from a circuit. Always check.
• Never open the enclosure of the internal power supply.
Statement 7012 Equipment Interfacing with AC Power Ports
Connect this equipment to AC mains that are provided with a surge protective device (SPD) at the service
equipment that complies with NFPA 70, the National Electrical Code (NEC).
Statement 7013 Equipment Grounding Systems—Common Bonding Network (CBN)
This equipment is suitable for installations using the CBN.
Statement 7018 System Recover Time
The equipment is designed to boot up in less than 30 minutes provided the neighboring devices are fully
operational.
Statement 8015 Installation Location Network Telecommunications Facilities
This equipment is suitable for installation in network telecommunications facilities.
Statement 8016 Installation Location Where the National Electric Code (NEC) Applies
This equipment is suitable for installation in locations where the NEC applies.
occurs, you can quickly turn off the power.
• Installing or removing a chassis.
• Working near power supplies.
cables, frayed power cords, and missing safety grounds.
General Safety Guidelines For Electrical Equipment
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
11