Preface; Document Revision History; Audience - Cisco SCE 1000 Installation And Configuration Manual

Preface

This preface describes who should read the SCE 1000 2xGBE Installation and Configuration
Guide, how it is organized, and its document conventions.

Document Revision History

Cisco Service Control Release
Release 3.0
D
ESCRIPTION OF
Added the following new features:
Redundant management (Mng) port
•
Release 2.5.7

Audience

This guide is for the networking or computer technician responsible for installing and configuring
the SCE 1000 platform on-site. To use this publication, you should be familiar with
telecommunications equipment and installation procedures, as well as electronic circuitry and
wiring practices. You should also have experience as an electronic or electromechanical
technician.
This installation guide explains the initial hardware installation and basic configuration
procedures for the SCE 1000. It contains procedures for unpacking and installing the device and
performing basic configuration via the setup wizard. After completing the installation and basic
configuration procedures covered in this guide, you will then use the appropriate companion
publications to more completely configure your system.
This guide contains instructions on how to install and run the SCE 1000 platform. This guide
assumes a basic familiarity with telecommunications equipment and installation procedures.
OL-7821-04
Part Number
OL-7821-03
C
HANGES
OL-782103
Cisco SCE 1000 2xGBE Installation and Configuration Guide
Publication Date
December, 2005
August, 2005
vii