Configuring E2E Reliability - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
l
l
----End

12.4.3.6 Configuring E2E Reliability

This topic describes how to configure end-to-end (E2E) protection schemes for the enterprise
private line service which has a high requirement on service reliability.
Context
Reliability covers equipment reliability, upstream networking protection, and downstream
networking protection. For details on reliability data planning, see
Reliability Data
Issue 01 (2014-04-30)
Based on 13.2.3 Principle of QoS Data
scheduling and are mapped to queues based on priorities.
huawei(config)#queue-scheduler strict-priority
huawei(config)#cos-queue-map cos0 0 cos1 1 cos2 2 cos3 3 cos4 4 cos5 5 cos6 6
cos7 7 //System default
Configure system security policies.
– Enable deny of service (DoS) anti-attack on the OLT.
1. Run the security anti-dos enable command to globally enable DoS anti-attack.
2. Run the security anti-dos control-packet policy command to configure a
protocol packet processing policy that will be used when a DoS attack occurs.
3. Run the security anti-dos control-packet rate command to configure the
threshold for the rate of sending protocol packets to the CPU.
– Enable IP address anti-attack on the OLT.
Run the security anti-ipattack enable command to enable IP address anti-attack.
Configure user security policies.
– Enable MAC address anti-flapping on the OLT.
Run the security anti-macduplicate enable command to enable MAC address anti-
flapping.
– Enable IP address anti-spoofing on the OLT.
1. In global config mode, run the security anti-ipspoofing enable command to
globally enable IP address anti-spoofing.
2. Enable IP address anti-spoofing at VLAN level, perform the following operations
to enable IP address anti-spoofing in service profile mode:
a. Run the vlan service-profile command to create a VLAN service profile.
b. Run the security anti-ipspoofing enable command to enable IP address
anti-spoofing at VLAN level.
c. Run the commit command to make the profile configuration take effect.
d. Run the quit command to quit the VLAN service profile mode.
e. Run the vlan bind service-profile command to bind the created VLAN
service profile to a VLAN.
– The service port level: In global config mode, run the security anti-ipspoofing
service-port serviceport-id enable command to enable IP address anti-spoofing at
the service port level.
Plan.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
12 FTTO Configuration(SOHO and SME)
Plan, all packets use strict priorities for queue
13.2.6 Principle of
1243