E-W-Mismatch - Cisco ONS 15327 User Documentation

Chapter 14 Alarm Troubleshooting
Always use the supplied ESD wristband when working with a powered ONS 15327. Plug the wristband
Caution
cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
Procedure: Clear the EQPT Alarm
Step 1 Perform a software reset on the reporting card:
a.
b.
c.
If the software reset fails to clear the alarm, physically reseat the card.
Step 2
Step 3 If the physical reseat of the card fails to clear the alarm, replace the card.
Note
14.4.37 EQPT-MISS
•
The replaceable equipment unit is missing (EQPT-MISS) alarm is reported against the fan-tray assembly
unit. It indicates that the replaceable fan-tray assembly unit is missing or not fully inserted.
Caution Always use the supplied ESD wristband when working with a powered ONS 15327. Plug the wristband
cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
Procedure: Clear the EQPT-MISS Alarm
If the alarm is reported against the fan object, check that the fan-tray assembly is present.
Step 1
If the fan-tray assembly is present, use the retractable handles embedded in the front of the fan tray to
Step 2
pull the fan-tray assembly forward several inches and then push the fan-tray assembly firmly back into
the ONS 15327 shelf assembly and close the retractable handles.
If no fan-tray assembly is present, obtain a fan-tray assembly and refer to the fan-tray assembly
Step 3
installation information in Chapter 1, Hardware Installation.

14.4.38 E-W-MISMATCH

•
June 2002
Display the CTC node view.
Position the CTC cursor over the slot reporting the alarm.
Right-click RESET CARD.
When replacing a card with an identical type of card, no additional CTC provisioning is
required.
Critical, Service-Affecting
Major, Service-Affecting
Cisco ONS 15327 User Documentation, R3.3
Alarm Procedures
14-33