ABB IRC5 Operating Manual page 563

134042, Volume not recorded
Description
Total consumed volume for the job is outside accepted
tolerance. Volume: arg
Consequences
Accuvol table will not be updated.
134050, Applicator Timeout
Description
A timeout occured while waiting for the applicator to get ready.
Recommended actions
Check other process messages for additional information.
134051, External Start when no program
Description
An External Start command (arg) was received when no
program was loaded
Probable causes
External controls system not compliant to protocol
134052, Overpush
Description
The system has pushed to much material
Consequences
The current paint job might be contaminated
Recommended actions
Disable paint push and then check push parameters
134053, Applicator configuration mismatch
Description
There is a mismatch between the number of applicator enable
signals and the number of brush signals.
Consequences
Robotware paint will not work properly
Recommended actions
Check the process configuration
134054, Command failed in e-stop state
Description
Command arg not allowed when the controller is in e-stop state.
Operating manual - Troubleshooting IRC5
3HAC020738-001 Revision: AA
Recommended actions
Remove emergency stop conditions and reset emergency stop
state.
134055, Configuration error
Description
Could not add arg.xml into the configuration settings. There
are too many configuration files.
Consequences
The option "arg" will be set to zero.
Recommended actions
Merge the configuration into another file, or increase the buffer
size.
134056, Configuration error
Description
Could not find the file: arg.xml
Consequences
The option "arg" will be set to zero.
Recommended actions
Make sure the file exists.
134057, Configuration error
Description
Could not parse the file: arg.xml
Consequences
The option "arg" will be set to zero.
Recommended actions
Fix the markup in the XML file.
134058, Configuration error
Description
Did not find the option in the file: arg.xml
Consequences
The option "arg" will be set to zero.
Recommended actions
Add the option into the XML file.
134059, XML-parser error
Description
First dimension passed to XML-parser was to big.
© Copyright 2005-2018 ABB. All rights reserved.
5 Troubleshooting by event log
Continues on next page
5.12 13 xxxx
Continued
563