ABB IRC5 Operating Manual page 233

Consequences
No data in the file may be accessed.
Probable causes
File may be write protected. File or directory may have incorrect
name. No storage space available on device.
Recommended actions
Check if the file is write protected, and in such case change the
setting. Make sure the file and directory names are correct.
Make sure there is enough storage space available.
40322, Load error
Description
Task arg: RAPID syntax error(s) in file arg.
Recommended actions
The source file to be loaded contains RAPID syntax errors.
Correct the source file.
40323, Load error
Description
Task arg: Syntax error(s) in header in file arg.
Recommended actions
The source file to be loaded contains syntax error in the file
header. Correct the source file. The syntax errors are logged
in a separate file.
40324, Load error
Description
Task arg: Keywords not defined in specified language (file arg).
Recommended actions
Cannot load RAPID source code in the national language
specified in the file header.
40325, Load error
Description
Task arg: A big enough free program memory block is not
available. The ordered operation could not be completed.
Probable causes
The program memory is full or fragmented.
Recommended actions
Check if large data structures could be split into smaller blocks.
Use of installed modules can save program memory.
Operating manual - Troubleshooting IRC5
3HAC020738-001 Revision: AA
40326, Load error
Description
Task arg: Parser stack full (file arg).
Recommended actions
The program is too complex to load.
40327, Load error
Description
Task arg: Not current RAPID version (file arg).
Recommended actions
Cannot load RAPID source code of the version specified in the
file header.
40328, Load error
Description
Task: arg.
Program memory is full. arg.
Recommended actions
The module arg could not be loaded because the program
memory is full.
Recovery: arg.
40329, Module installation failure
Description
Task: arg.
It is not possible to install a module from file arg.
Consequences
The module will not be installed.
Probable causes
There can be several different reasons. The RAPID module
may have RAPID errors. The file might not exist.
Recommended actions
Check the event messages in the Elog domain RAPID. Correct
the RAPID errors and Reset RAPID. Or make sure the correct
file is available to load. Reset RAPID.
40330, RAPID errors in installed module
Description
Task: arg. Module (line/column): arg. There is an error with
symbol: arg.
Consequences
The module will not be installed.
© Copyright 2005-2018 ABB. All rights reserved.
5 Troubleshooting by event log
Continues on next page
5.6 4 xxxx
Continued
233