ABB IRC5 Operating Manual page 395

arg.
Consequences
No communication with the adapter is possible.
71529, The destination address is missing
Description
The gateway address arg on network arg is defined, but no
destination is defined.
Consequences
The gateway will not be used since the destination is missing.
Recommended actions
Specify a destination address to be used in conjunction with
gateway address.
Or
Remove gateway address definition.
71530, The subnet mask is missing
Description
The subnet mask, on arg network, is missing. The arg network
is on connector arg.
Consequences
The arg network will not operate. No communication on arg
network is possible.
Probable causes
The subnet mask is missing.
Recommended actions
Add a subnet mask.
71531, Faulty destination address
Description
The given destination address arg, on arg network, is not
allowed. Doesn't follow the IP name standard or it's on the same
network as the scanner and the adapter.
Consequences
No destination is available.
Probable causes
The address given is not following IP address standard. The
address is equal to network address or gateway address. The
address is on the same network as network and gateway. The
address is equal to broadcast or network address.
Recommended actions
Provide a valid destination address.
Operating manual - Troubleshooting IRC5
3HAC020738-001 Revision: AA
71532, The gateway address is missing
Description
The destination address arg on arg is defined, but no gateway
address is defined.
Consequences
The destination address will not be used since the gateway
address is missing.
Recommended actions
Specify a gateway address to be used in conjunction with the
destination address.
Or
Remove destination address definition.
71533, Invalid configuration size for EtherNet/IP
adapter
Description
The adapter arg has an invalid configuration size. Maximum
configuration size supported is arg bytes.
Consequences
No communication with the adapter is possible.
Recommended actions
Correct the configuration size for the adapter in the I/O
configuration.
71534, Invalid output size for EtherNet/IP adapter
Description
The adapter arg has an invalid output size. Maximum output
size supported is arg bytes.
Consequences
No communication with the adapter is possible.
Recommended actions
Correct the output size for the adapter in the I/O configuration.
71535, Invalid input size for EtherNet/IP adapter
Description
The adapter arg has an invalid input size. Maximum input size
supported is arg bytes.
Consequences
No communication with the adapter is possible.
Recommended actions
Correct the input size for the adapter in the I/O configuration.
© Copyright 2005-2018 ABB. All rights reserved.
5 Troubleshooting by event log
Continues on next page
5.8 7 xxxx
Continued
395