Xxxx - ABB IRC5 Operating Manual

5.12 13 xxxx

130002, Equipment error
Description
Paint process stopped.
Recommended actions
Check the paint equipment.
130008, Trig plane error
Description
In 'SetBrush n': One trig plane,
arg, is defined outside
the programmed path.
Recommended actions
Change eventdata or reprogram path.
131000, Argument error.
Description
The argument is not an integer.
Recommended actions
Change the argument to an integer.
131006, Argument value error
Description
Negative value for argument no. arg
Recommended actions
Change argument value to
a positive number.
131007, Signal 'arg' does not exist
Description
Signal: arg
Task: arg
Context: arg
Recommended actions
Check signal definitions.
Define signal or find an existing signal.
131013, Non-existing signal
Description
The following signal did not exist:
'arg'
Operating manual - Troubleshooting IRC5
3HAC020738-001 Revision: AA
Recommended actions
Check signal definitions.
Define signal or find an existing signal
131015, Too many trig events
Description
The maximum number of trig events (10) between two PaintL
instructions is exceeded.
Task: arg
Instruction: arg
Context: arg
Recommended actions
Reduce the number of trig events.
131016, Illegal value for signal arg
Description
An attempt was made to set an illegal value arg for signal arg.
Consequences
Signal will not be set.
Recommended actions
Check that signal is within defined limits.
131017, SetBrushFac: Illegal applicator number
arg
Description
Device AargBrush not found.
Consequences
Brush factor is not set.
Recommended actions
Check IPS config that device exists for this applicator number.
131018, SetBrushFac: Illegal factor or channel
number
Description
Channel arg is invalid or
factor arg outside limit. (Range: 1-200%)
Consequences
Brush factor is not set.
Recommended actions
Check channel number and factor.
© Copyright 2005-2018 ABB. All rights reserved.
5 Troubleshooting by event log
Continues on next page
5.12 13 xxxx
541