ABB IRC5 Operating Manual page 298

5 Troubleshooting by event log
5.6 4 xxxx
Continued
Probable causes
No configuration has been added for the RAPID Message
Queue.
Recommended actions
Add configuration for the RAPID Message Queue.
41698, RMQ Error - Faulty use of instruction
Description
Task: arg.
Instruction arg can only be used on normal level, not in a TRAP
routine or service routine.
Program ref: arg.
Consequences
The program execution is stopped immediately.
Probable causes
Instruction arg used on wrong level.
Recommended actions
Use instruction on normal level.
41699, RMQ Error - Max size for message
exceeded
Description
Task: arg.
The size of the data in arg exceeds maximum size.
Program ref: arg.
Consequences
The message will not be sent.
Probable causes
Trying to send larger messages then allowed. The receiving
client is not configured to receive the size of the message sent.
Recommended actions
Change the size of the RMQ for the receiver, or send smaller
messages.
Recovery: arg.
41700, RMQ Error - Interrupt setup failed
Description
Task: arg.
Two different interrupt identities cannot be used for the same
data type in instruction arg. Each data type need a unique
interrupt identity and unique TRAP routine.
Program ref: arg.
Consequences
The program execution is stopped immediately.
Continues on next page
298
Probable causes
Same data type is used in two arg instructions with two different
interrupt identities.
Recommended actions
A unique interrupt identity is needed for each data type when
order and enable interrupts for a specific data type.
41701, RMQ Error - No message to collect
Description
Task: arg.
Instruction arg failed. There was no message to collect.
Program ref: arg.
Consequences
No message was collected.
Probable causes
This can happen if the power fail occur between the trap was
ordered and the instruction arg was executed.If multiple use of
arg in a TRAP routine.If using arg in a TRAP routine that execute
without any new message in the RMQ.
Recommended actions
Recovery: arg.
41702, RMQ Error - arg not valid
Description
Task: arg.
Use of non-valid data in argument arg.
Program ref: arg.
Consequences
The program execution is immediately stopped.
Probable causes
Use of a variable arg that not contain any valid data. The
variable has only been initialized, no valid data has been copied
to the variable.
Recommended actions
Check the RAPID program.
41703, RMQ Error - Data could not be copied
Description
Task: arg.
The data type arg exceeds the maximum size supported for the
RMQ configured for task arg.
Program ref: arg.
Consequences
No message has been received.
© Copyright 2005-2018 ABB. All rights reserved.
Operating manual - Troubleshooting IRC5
3HAC020738-001 Revision: AA