ABB IRC5 Operating Manual page 259

40789, Limitation Error
Description
Task: arg.
The string length of the argument for the file path is too long.
Program ref: arg.
Probable causes
The maximum allowed string length for the full system file path
is arg characters.
Recommended actions
Shorten the length of the path.
40790, Value Error
Description
Task: arg.
The RAPID string is too long.
Program ref: arg.
Probable causes
String value exceeds the maximum allowed length.
Recommended actions
Rewrite the program to use strings of less length.
Recovery: arg.
40791, I/O Error
Description
Task: arg.
No space left on device (file name arg).
Program ref: arg.
Recommended actions
Recovery: arg.
40792, I/O Error
Description
Task: arg.
File open/access error for path arg.
Program ref: arg.
Recommended actions
Check permission, is the file write protected? Check if the file
or directory exists. Check if there is any space left on device.
Recovery: arg.
40793, Error Installing Text Table
Description
Task: arg.
Operating manual - Troubleshooting IRC5
3HAC020738-001 Revision: AA
No or faulty text resource name or index number in the text file.
Program ref: arg.
Consequences
The contents of some of the text tables may have been
destroyed.
Recommended actions
Correct the error, reset the system and try again.
40794, Error Installing Text Table
Description
Task: arg.
The specified index within the text resource already exists in
the system.
Program ref: arg.
Probable causes
Error in the index numbering. The file has been installed twice.
Recommended actions
If error in the index, correct it, reset the system and try again.
40795, Error Installing Text Table
Description
Task: arg.
System memory for text tables is full.
Program ref: arg.
Recommended actions
Reduce the amount of user defined text string installed from
RAPID. Reset the system and try again.
40796, Overload Error
Description
Task: arg.
The system is overloaded so the actual order cannot be ready
in time.
Program ref: arg.
Recommended actions
Reduce the main computer load, for example by: Add WaitTime
in RAPID loops. Increase filter time for I/O signals. Avoid cyclic
interrupts.
40797, I/O Error
Description
Unable to access the I/O signal arg on I/O device arg.
© Copyright 2005-2018 ABB. All rights reserved.
5 Troubleshooting by event log
Continues on next page
5.6 4 xxxx
Continued
259