Destination Ipv4 Unicast - Cisco NCS 1004 Command Reference Manual

destination ipv4 unicast

destination ipv4 unicast
To specify the destination of a GMPLS UNI tunnel, use the destination ipv4 unicast command in GMPLS
UNI controller tunnel-properties configuration sub-mode.
destination ipv4 unicast address
Syntax Description
address
None
Command Default
GMPLS UNI controller tunnel-properties configuration
Command Modes
Command History
Release
Release
7.0.1
Example
The following example shows how to specify a tunnel destination (10.10.3.4).
RP/0/RP0/CPU0:ios(config)#mpls traffic-eng
RP/0/RP0/CPU0:ios(config-mpls-te)#gmpls optical-uni
RP/0/RP0/CPU0:ios(config-te-gmpls)#controller Optics0/0/0/0
RP/0/RP0/CPU0:ios(config-te-gmpls-cntl)#tunnel-properties
RP/0/RP0/CPU0:ios(config-te-gmpls-tun)#destination 10.10.3.4
RP/0/RP0/CPU0:ios(config-te-gmpls-tun)#
Command Reference for Cisco NCS 1004
20
Specifies the tunnel destination (IPv4 address).
Modification
This command is
introduced.
Commands