Show Line Vty - Cisco SCE 1000 Installation And Configuration Manual

Hide thumbs Also See for SCE 1000:
Table of Contents

Advertisement

Chapter 8
Troubleshooting
CLI command
show access-lists
• Telnet
• CLI command
connection
show interface
cannot be
mng
established
• Mng LINK LED
is not lit (link is
down)
• Telnet
CLI command:
connection
show telnet
cannot be
status
established
• Mng LINK LED
is lit (link is up)
CLI command:
show telnet
sessions
CLI command:
show ip default-
gateway
CLI command:
show ip route
<host-ip-address>
CLI commands:
• show access-
lists

• show line vty

access-class
show ip access-
class
OL-7821-04
An ACL may be assigned
that denies entry.
Management interface IP
address or subnet mask is
incorrect.
Telnet server is disabled.
Too many Telnet
connections (up to 5
concurrent sessions are
supported).
Default gateway is incorrect
(when the host used as client
is not in the same network
as the SCE Platform).
Routing tables are
incorrectly configured
(when the host used as client
is not in the same network
as the SCE Platform, and
there is more than one
gateway on the SCE
Platform network).
Host is not a member of a
valid access-list.
Cisco SCE 1000 2xGBE Installation and Configuration Guide
Problem Solving Using a Subsystems Approach
See
Initial System Configuration
page 5-3)
Refer to "Access Control Lists" in
the Cisco Service Control Engine
(SCE) Software Configuration Guide.
Check / reconfigure management
port IP address and subnet mask
Enable Telnet server:
service telnetd
Close one or more of the open Telnet
sessions.
Check / reconfigure default gateway.
See
Initial System Configuration
page 5-3)
Refer to "IP Configuration" in the
Cisco Service Control Engine (SCE)
Software Configuration Guide.
Check / reconfigure routing tables.
See
Initial System Configuration
page 5-3)
Refer to "IP Configuration" in the
Cisco Service Control Engine (SCE)
Software Configuration Guide.
Check / reconfigure access-list.
See
Initial System Configuration
page 5-3)
Refer to "Access Control Lists" in
the Cisco Service Control Engine
(SCE) Software Configuration Guide.
(on
(on
(on
(on
8-13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sce 1000 2xgbe

Table of Contents