Power Supply Module - Cisco 3100 Manual

Power Supply Module

9
11
For More Information
Power Supply Module
See Product ID Numbers, on page 33
supply modules.
Note
Note
Attention
Note
AC Power Supply
The dual power supplies can supply up to 800-W power across the input voltage range. The load is shared
when both power supply modules are plugged in and running at the same time.
Overview
24
Power LED
Six network activity LEDs:
• Amber—No connection, or port is not in
use, or no link or network failure.
• Green—Link up, no network activity.
• Green, flashing—Network activity.
• See 8-Port 10/100/1000Base-T Network Module with Hardware Bypass, on page 19
of the 1-Gb network module.
• See 8-Port 1/10/25-Gb Network Module, on page 15
module.
• See 4-Port 40-Gb Network Module, on page 17
• See Install, Remove, and Replace the Network Module
network modules.
You cannot mix AC and DC power supply modules in the chassis.
After removing power from the chassis by unplugging the power cord, wait at least 10 seconds before turning
power back ON. You want to keep the system power off, including the standby power, for 10 seconds.
Make sure that one power supply module is always active.
The system power requirements are lower than the power supply module capabilities. See the following table.
10 Handle ejector
—
for a description of the 1/10/25-Gb network
for a description of the 40-Gb network module.
for the procedure for removing and replacing
for a list of the PIDs associated with the Secure Firewall 3100 power
Overview
for a description