Clear The Lcas-Rx-Fail Condition; Lcas-Tx-Add; Lcas-Tx-Dnu - Cisco ONS 15310-CL Troubleshooting Manual

1.7.126 LCAS-TX-ADD

For more information about Ethernet cards, refer to the Cisco ONS 15310-CL and Cisco ONS 15310-MA
Note
Ethernet Card Software Feature and Configuration Guide.
ONS 15310-CL ML-100T-8-Series cards are LCAS-enabled.
Note

Clear the LCAS-RX-FAIL Condition

Check for and clear any line or path alarms using the procedures in this chapter.
Step 1
If the condition does not clear, log into the Technical Support Website at
Step 2
http://www.cisco.com/techsupport for more information or call Cisco TAC (1 800 553-2447).
1.7.126 LCAS-TX-ADD
The LCAS VCG Member Transmit-Side-In Add State condition is raised against ML-100T-8 Ethernet
and CE-series cards when the transmit side of an LCAS VCG member is in the add state. The condition
clears after provisioning is completed. The condition clears after provisioning is completed. The remote
likely reports a path condition such as an
page
LCAS-TX-ADD is an informational condition and does not require troubleshooting.
Note
For more information about Ethernet cards, refer to the Cisco ONS 15310-CL and Cisco ONS 15310-MA
Note
Ethernet Card Software Feature and Configuration Guide.

1.7.127 LCAS-TX-DNU

The LCAS VCG Member Transmit-Side-In Do Not Use (DNU) State condition is raised on ML-100T-8
Ethernet and CE-100T cards when the transmit side of an LCAS VCG member is in the DNU state. For
a unidirectional failure, this condition is only raised at the source node. The LCAS-TX-DNU condition
is raised when the cable is unplugged.
The remote node likely reports a path alarm such as AIS-P or UNEQ-P.
LCAS-TX-DNU is an informational condition and does not require troubleshooting.
Note
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-84
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SONET Logical Objects: STSTRM, VT-TERM
1-143.
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SONET Logical Objects: STSTRM, VT-TERM
"AIS-P" condition on page 1-19
Chapter 1 Alarm Troubleshooting
or an "UNEQ-P" alarm on
78-17235-01